Step-by-step guidance

Slow WiFi on a Deco M5 network can come from the internet service, a weak connection between mesh units, interference, or the device being tested. Compare the same device in a few locations before changing settings; this helps show where the slowdown begins.
Establish a useful baseline
- Pause large downloads or streaming on other devices while testing.
- Run the same speed test on one device near the main Deco, then in the room where WiFi seems slow.
- If possible, connect a computer by Ethernet to the main Deco and compare that result with the wireless test.
- Repeat the test at a different time if the result varies significantly.
The Deco app’s internet speed test measures the connection at the main unit, not necessarily the speed a particular phone or computer receives. An older client adapter, a weak signal, and a busy network can each produce a different result.
Check the satellite connection and placement
Open the Deco app and review the network map or status for each unit. If the main unit performs normally but devices behind one satellite are slow, move that satellite closer to the main Deco for a test. Place it in an open, elevated spot between the main unit and the area that needs better coverage. Walls, cabinets, appliances, and other obstacles can reduce the mesh link.
If the issue remains at the satellite’s original room after swapping its location with another unit, the room or surrounding interference may be the limiting factor. If the problem follows the same satellite, check its power and app status and consult the model guide.
Check the device, not just the Deco
If just one phone or laptop is slow, reconnect it to WiFi, restart it, and check for operating-system or wireless-adapter updates. Confirm it is connected to your intended network and has not held onto a farther Deco node. Test another device in the same spot; if that device is faster, troubleshoot the first device separately.
When every device is slow
Check that the modem has internet service and the Ethernet cable to the main Deco is secure. If practical, test the internet connection using your provider’s recommended method. If that test is slow too, contact the ISP before changing Deco settings. Keep the Deco app and firmware current, but review the update prompt and release details before proceeding.
Avoid a factory reset as an early speed fix because it removes saved settings. For additional detail, read TP-Link’s Deco speed test and slow internet guide and official Deco M5 downloads and manual. You can also browse our general slow Deco WiFi guide. This accompanying image is illustrative and may not depict exact Deco M5 hardware.
For further help, explore our independent TP Link Deco support services or contact our team with a non-sensitive description of the issue. Do not send passwords or verification codes.

