Step-by-step guidance

The Deco M5 setup flow uses the Deco app to create a network, connect the main unit to your modem, and add any other units in your kit. Hardware versions and app screens can differ, so choose the Deco M5 entry that matches your device and follow the current in-app directions.
Before you begin
Install the Deco app from your phone’s official app store and sign in with the TP-Link account you plan to use for this network. Check the model label so you can select Deco M5 rather than a similar-looking model. Keep the modem, an Ethernet cable, and the M5 power adapter nearby. If your internet provider requires account credentials or other connection details, confirm them with the provider first.
Configure the main Deco M5
- Open the app and start creating a Deco network. Select Deco M5 and follow the prompts.
- Power off the modem if the provider’s instructions recommend it. Connect the modem to one of the M5’s Ethernet ports, then power on the modem and Deco.
- Wait for the M5’s setup-ready indicator and let the app discover the unit. If the phone asks for a local network or nearby-device permission, allow it while completing setup.
- Select the internet connection type in the app. If you are unsure which type or provider-specific value to use, check with your ISP instead of entering guesses.
- Create a WiFi name and password, then connect your phone and other devices to the new network as prompted.
Add extra M5 units
If your kit has more than one Deco M5, use the app’s option to add another Deco. Power on each additional unit and follow the app’s instructions one at a time. Place units where they can maintain a good connection to the existing mesh; a node at the far edge of weak coverage may not improve the room you are trying to reach.
Troubleshoot a setup that will not complete
The app cannot find the M5: Confirm the phone has WiFi and Bluetooth available if the app requests them, check local network permission, and select the correct M5 model. Restart the app and try again. If the unit has been set up before, check for the existing network under the correct account before resetting it.
The internet connection test fails: Reseat the Ethernet cable, check that the modem has internet service, and confirm the connection type with your provider. If the provider’s modem is in router mode, setup details can differ from a direct modem connection.
An added M5 stays offline: Move it closer to the main Deco temporarily, check its power, and wait for the app to update its status. Restart the unit if needed, but use the model guide before performing a factory reset.
The M5 guide and available downloads are on the official Deco M5 support page. For basic placement and speed checks, see our slow Deco WiFi troubleshooting guide.
For further help, explore our independent TP Link Deco support services or contact our team with a non-sensitive description of the issue. Do not send passwords or verification codes.

